自動混凝土攪拌機發生故障時時候，若沒有及時將攪拌罐內的清理出來，時間一久將會凝固，會給我們帶來很大的經濟損失。那么你知道自動混凝土攪拌機已凝固水泥怎么弄干凈？下面介紹下相關的方法吧。

　　When the automatic concrete mixer fails, if the mixing tank is not cleared out in time, it will solidify for a long time, which will bring us great economic losses. Then do you know how to clean the set cement in the automatic concrete mixer? Here are the relevant methods.

　　準備好緊急驅動軟管，將故障自動混凝土攪拌機熄火，卸下液壓馬達上的高壓油管接頭。將救援車熄火，將其液壓馬達的高壓油管卸下，并與故障車上的對應接頭用緊急驅動軟管相連。發動救援車，將其操縱手柄撥出料位置，故障車內的商品混凝土即被排出。緊急驅動完畢后，將驅動軟管卸下，并恢復兩車原狀。

　　Prepare emergency drive hoses, turn off the faulty automatic concrete mixer and remove the high-pressure tubing connector from the hydraulic motor. Turn off the rescue vehicle, remove the high-pressure tubing of its hydraulic motor, and connect it to the corresponding joint of the faulty vehicle with an emergency drive hose. Start the rescue vehicle and shift its control handle to the discharging position, and the commercial concrete in the faulty vehicle will be discharged. After the emergency drive is completed, remove the drive hose and restore the two cars to their original condition.

　　若個方法實行有困難，則必須采用以下方法，立即排出商品混凝土。在托輪和滾道之間放入木楔，以控制攪拌筒的旋轉，一定要注意；將發動機熄火，拆松液壓馬達的一根高壓油管，攪拌筒可自由旋轉，控制攪拌筒的旋轉，使維修孔轉到下部，然后打開維修孔，清理出筒內商品混凝土。此時一定要注意，商品混凝土排出完畢后，恢復自動混凝土攪拌機原狀。

　　If the first method executes have difficulty, criterion must use the following method, eduction commodity concrete immediately. A wooden wedge is placed between the supporting wheel and the raceway to control the rotation of the mixing cylinder, and safety must be paid attention to; Turn off the engine, loosen a high-pressure oil pipe of the hydraulic motor, and the mixing cylinder can rotate freely, control the rotation of the mixing cylinder, so that the maintenance hole is turned to the lower part, and then open the maintenance hole and clean out the commercial concrete in the cylinder. At this time, we must pay attention to safety. After the discharge of concrete, restore the automatic concrete mixer to its original state.

　　另外，直接將自動混凝土攪拌機發動機外部清洗劑均勻噴灑于浸濕后，攪拌車發動機及引擎室周邊，待幾分鐘后，用纖維毛刷清洗引擎室內所能觸及到的所有部件。將自動混凝土攪拌機發動機外部清洗劑噴灑于引擎表面，操作步驟同上，周而復始，直將發動機外表清洗干凈。沖洗干凈的發動機用半濕性毛巾擦干，并用吸塵吸水風干機將手不易觸及到的地方吸干，然后風干。

　　In addition, directly spray the external cleaning agent of the engine of the automatic concrete mixer evenly on the engine and the surrounding of the engine room of the mixer after soaking. After a few minutes, clean all the parts that can be touched in the engine room with the fiber brush. Spray the external cleaning agent on the engine surface of the automatic concrete mixer. Repeat the procedure as above until the engine surface is cleaned. The rinsed engine is dried with a semi-wet towel, and the area hard to reach by hand is sucked dry with a suction air dryer, and then air dried.

　　自動混凝土攪拌機已凝固水泥怎么弄干凈？在這里講了兩種方法，在自動混凝土攪拌機發生故障的時候，及時清理，將損失降到很低很低才行。如果您想了解更多的內容，就來我們網站www.gdfcx.net咨詢吧。

　　Automatic concrete mixer has set cement how to clean? Here are two methods, in the automatic concrete mixer failure, timely cleaning, will be very low loss to very low. If you want to know more, please consult our website www.gdfcx.net.