如今小型攪拌機的使用頻率是越來越高了，很多購買攪拌機的人對于如何選購攪拌機還是有些模糊的，今天我們就來說說攪拌機的選購點——動力匹配，這對車輛來說是非常重要的，動力匹配的好，車輛的性能才能發揮很好，做起事來才能事半功倍。

Nowadays, small mixers are used more and more frequently. Many people who buy mixers are still vague about how to purchase mixers. Today, let's talk about the selection point of mixers - power matching, which is very important for vehicles. Only good power matching can give full play to the vehicle's performance and do things with half the effort.

1、發動機馬力的選擇，對于同一企業的發動機，馬力越大，加速性能越好，爬坡性能越好、重載時高車速越大，運行時換擋的次數越少。因此如果想要你的攪拌機加速快，爬坡性能好，車速高，減少換擋次數，那就好選擇相對馬力較大的發動機，說的相對就是適當的，不能是馬力太大，那就會造成浪費的。

1. For the selection of engine horsepower, for engines of the same brand, the higher the horsepower, the better the acceleration performance, the better the climbing performance, the higher the high speed under heavy load, and the less the shift times during operation. Therefore, if you want your mixer to accelerate fast, have good climbing performance, have high speed, and reduce the number of gear changes, you should choose an engine with relatively high horsepower. That's appropriate. It can't be that the horsepower is too high, which will cause waste.

2.變速箱選擇，一般來說檔的位數越多，1檔時爬坡性能越好，檔位數越多，換擋時發動機轉速變化月小，整車的使用就更加經濟省油；變速器扭矩，變速器的額定輸入扭矩不能小于發動機的大扭矩。

2. For gearbox selection, generally speaking, the more the number of gears, the better the climbing performance at first gear, the more the number of gears, and the smaller the monthly change of engine speed when shifting, the more economical and fuel efficient the use of the whole vehicle; Transmission torque. The rated input torque of the transmission shall not be less than the large torque of the engine.

3.車輛后橋的選擇，攪拌機的承載力主要依靠后橋，后橋的速比月小，同等條件下高車速越高，經濟車速越高，經濟車速越高，車輛就越省油，但是車輛的爬坡就差點，高檔加速能力就差些。

3. The selection of the rear axle of the vehicle and the bearing capacity of the mixer mainly depend on the rear axle. The speed ratio of the rear axle is small in months. Under the same conditions, the higher the high speed, the higher the economic speed, and the higher the economic speed, the more fuel efficient the vehicle will be. However, the climbing ability of the vehicle is poor, and the high-end acceleration ability is poor.

4.單雙級強的選擇，單級橋只有主減速器一對齒輪嚙合，傳動效率高，省油；雙級橋有主減和輪邊減速兩對齒輪嚙合，傳動效率低，但是半軸上扭矩小，可靠性比較高。

4. Single and double stage strong selection. The single stage axle only has a pair of gears engaged in the main reducer, with high transmission efficiency and fuel saving; The two-stage axle has two pairs of gears, the main reducer and the wheel side reducer, which are engaged. The transmission efficiency is low, but the torque on the axle shaft is small and the reliability is high.

5.動力總成選擇，大功率發動機+直接檔+小速比的優勢：大功率換擋減少，保證小型攪拌機的發動機工作在經濟轉速區，爬坡動力強；直接換擋變速器+小速比后橋可以實現和超速檔變速器+大速比后橋相同的小傳動比，兩種配置經濟車速一致；直接檔嚙合齒輪數量較少，傳動效率較高，節油性好。

5. Powertrain selection, advantages of high-power engine+direct gear+small gear ratio: reduce high-power gear shifting, ensure that the engine of small mixer works in the economic speed zone, and have strong climbing power; The direct shift transmission+small gear ratio rear axle can achieve the same small transmission ratio as the overdrive transmission+large gear ratio rear axle, and the two configurations have the same economic speed; The number of direct gear meshing gears is small, the transmission efficiency is high, and the fuel economy is good.

6.一般情況下經常使用高檔行駛的攪拌機，建議使用直接檔+小速比配置；經常使用次高檔行駛的攪拌機，好使用超速檔+大速比配置。

6. Generally, high-grade mixers are often used, and it is recommended to use direct gear+small speed ratio configuration; Always use the mixer running in the middle and high grades, and it is easy to use the overspeed gear+high speed ratio configuration.

對于動力匹配的選擇你們了解了嗎？如果對此您還是有不理解的地方，歡迎來我們網站http://www.gdfcx.net進行咨詢了解。

Do you understand the choice of power matching? If you still don't understand this, welcome to our website http://www.gdfcx.net Ask about it.