自動混凝土攪拌機經常在使用過程中遇到各種故障，引起故障的原因，無非也就三種。一種是操作不當，一種是維護保養不到位，一種是潤滑沒做好。

Automatic concrete mixers often encounter various failures in the process of use. There are only three causes of failures. One is improper operation, the other is inadequate maintenance, and the other is inadequate lubrication.

大多數的故障，都是由操作不當導致的。大數據顯示，大多數機械由于長期操作不當，使用一段時間后都會有大大小小的故障，間接縮短了使用壽命。為了避免長期不當操作，建議您定期查閱自動混凝土攪拌機培訓手冊和使用說明書，養成良好的操作習慣。

Most failures are caused by improper operation. Big data shows that due to long-term improper operation, most machines will have large and small failures after a period of use, which indirectly shortens the service life. In order to avoid long-term improper operation, it is recommended that you regularly consult the training manual and operation manual of the automatic concrete mixer to develop good operation habits.

良好的操作習慣是基本要求，良好的維護保養也很重要。小型挖掘機施工的環境通常很惡劣，長時間在這種環境下施工對機械損耗特別大。如果能做好維護保養，可以避免很多故障的產生。

Good operation habits are basic requirements, and good maintenance is also important. The construction environment of small excavators is usually very harsh, and the construction in this environment for a long time will cause great mechanical loss. If maintenance can be done well, many failures can be avoided.

還有就是潤滑問題，人長時間缺水就會口干舌燥，機械長時間缺潤滑劑就會加速磨損。定期給各個零部件添加潤滑劑，保持良好的潤滑習慣，能很大程度上提高機械的使用壽命。

There is also the problem of lubrication. People will be thirsty if they lack water for a long time, and machinery will wear faster if they lack lubricant for a long time. Regularly add lubricant to all parts and keep good lubrication habits, which can greatly improve the service life of machinery.

此外啟動前，攪拌桿應處于中位，液壓油箱油位應在規定范圍內。啟動后，先將操縱桿置于“卸料”位置，以排除攪拌筒內積水。裝料時，操縱桿置于“裝料”位置，調節攪拌筒轉速。

In addition, before starting, the mixing rod should be in the middle position, and the oil level in the hydraulic oil tank should be within the specified range. After starting, first place the control lever at the "unloading" position to drain the water in the mixing drum. When loading, place the control lever at the "Loading" position to adjust the rotation speed of the mixing drum.

攪拌筒內的混凝土量須符合運輸車輛的規定。運輸前，卸料槽須鎖定在“驅動”位置。運輸時攪拌筒應低速轉動。

The amount of concrete in the mixing drum must meet the requirements of the transport vehicle. The discharge chute must be locked in the "drive" position before transport. The mixing drum shall rotate at low speed during transportation.

作業結束后須關閉內燃機，清洗料槽、攪拌筒進口和托輪，并混凝土結塊。進入攪拌筒進行清洗時，取下內燃機電鑰匙，鎖好門窗，并在筒外設置監護人。操作完畢，將各把手置于中位，鎖好門窗。

After the operation, the internal combustion engine must be shut down, the feed tank, the mixing drum inlet and the supporting wheel must be cleaned, and the concrete caking must be removed. When entering the mixing drum for cleaning, take down the internal combustion engine electrical and mechanical key, lock the doors and windows, and set up a supervisor outside the drum. After the operation, put the handles in the middle position and lock the doors and windows.

自動混凝土攪拌機廠家溫馨提示：以上三點做的好不好，將直接影響到自動混凝土攪拌機的故障率。所以您對以上所講解內容要多多關注，關注我們http://www.gdfcx.net了解更多事項！

The manufacturer of the automatic concrete mixer kindly reminds that the failure rate of the automatic concrete mixer will be directly affected by the above three points. So you should pay more attention to the above contents and pay attention to us http://www.gdfcx.net Learn more!