小型攪拌機的日常維護要點有什么呢？實際上為了更好更順利更長久的使用該設備，就應該來了解這方面的信息，下面小編為您講解七點。

What are the key points for daily maintenance of small mixers? In fact, in order to use the device more smoothly and for a longer time, you should learn about this information. Here are seven points to explain.

1、主機的光滑檢查。在攪拌主機工作時,可查詢光滑脂泵刮油器是不是在正常工作的刮油。

1. Smoothness check of the host. When the mixing host is working, you can check whether the grease pump oil scraper is working normally.

2、查詢光滑脂泵壓力表值正常狀況下工作壓力為10,壓力若低于10可能為光滑脂泵泵芯梗塞,假如壓力高于60可能為分配閥梗塞或許后邊地管路梗塞。

2. Query the pressure gauge value of the smooth grease pump. Under normal conditions, the working pressure is 10. If the pressure is lower than 10, the smooth grease pump core may be blocked. If the pressure is higher than 60, the distribution valve may be blocked or the rear pipeline may be blocked.

3、在每個軸頭有一個備用黃油嘴用手指甲壓下黃油嘴的頂珠,如有光滑脂出,則證明軸頭光滑到位,反之則證明軸頭光滑不到位。

3. There is a spare grease fitting on each axle head. Press the top bead of the grease fitting with your fingernail. If there is any smooth grease, it means that the axle head is smooth and in place. Otherwise, it means that the axle head is smooth and not in place.

4、在自動出產狀態下攪拌主機卸料門手入手柄應處于收回方位,且球閥處于中位,兩個手自動改換螺堵應全部擰緊,防止手油泵過早損壞。

4. In the automatic production state, the manual inlet handle of the discharge door of the mixing host should be in the retracted position, and the ball valve should be in the middle position. The two manual automatic replacement plugs should be fully tightened to prevent premature damage of the manual oil pump.

5、攪拌主機減速箱應留意及時加油和換油檢查齒輪油是不是滿足,要保證可以查詢其示油器的油位。

5. The reduction gearbox of the mixing host shall be filled and replaced in time to check whether the gear oil meets the requirements and ensure that the oil level of the oil indicator can be checked.

6、檢查減速箱有無漏油的表象叫板主機減速箱易漏處為輸入、輸出軸封處,油溫傳感器處。

6. Check whether there is oil leakage in the reducer. The vulnerable parts of the reducer of the main engine are the input and output shaft seals and the oil temperature sensor.

7、攪拌軸、攪拌葉片每個工作周期應清洗,防止結料和抱軸。

7. The mixing shaft and mixing blade shall be cleaned in each working cycle to prevent material binding and shaft holding.

小型攪拌機的七點日常維護要點具體內容就到這里了，您對此有什么想法就來網站http://www.gdfcx.net咨詢吧！

Here are the seven points for daily maintenance of small mixers. If you have any ideas, please come to the website http://www.gdfcx.net Consult!