什么原因導致攪拌機存在抱軸問題呢？小型攪拌機廠家認為可能是原料投料位置問題。攪拌混凝土所用的物料主要是砂石骨料、水泥、粉煤灰、水和外加劑等。原料水泥若包裹砂石遇水結塊，如果攪拌不充分就容易粘在攪拌軸上，若水泥進料口位置方向不合理，使攪拌軸不能快速充分攪拌，就容易形成抱軸現象。

What causes the shaft holding problem of the mixer? The manufacturer of small mixer thinks that it may be the problem of raw material feeding position. The materials used for mixing concrete are mainly sand aggregate, cement, fly ash, water and additives. If the raw cement is wrapped with sand and gravel and agglomerates in water, it is easy to stick to the mixing shaft if the mixing is not sufficient. If the position and direction of the cement feed inlet are unreasonable, the mixing shaft cannot be quickly and fully mixed, and it is easy to form the phenomenon of shaft holding.

或者是攪拌主機進水管與沖水位置原因。沖水點位置和沖洗方向不正確的話，又或者是沖水壓力過低，導致水在進入主機內部后，不能講暫時粘結在軸上的混凝土沖洗掉，則時間久了就容易形成抱軸。

Or the water inlet pipe and flushing position of the mixing host. If the position and direction of the flushing point are incorrect, or the flushing pressure is too low, so that the concrete temporarily bonded to the shaft cannot be washed off after the water enters the main engine, it is easy to form a shaft holding after a long time.

也可以生產之后沒有及時對攪拌機內部進行清洗，或清洗不干凈，導致攪拌軸表面仍有殘留的混凝土，干燥后凝固在攪拌軸上，如果長期如此則非常容易產生抱軸現象。

It is also possible that after production, the internal part of the mixer is not cleaned in time, or the cleaning is not clean, which leads to the residual concrete on the surface of the mixing shaft, which solidifies on the mixing shaft after drying. If this is done for a long time, it is very easy to produce the phenomenon of holding the shaft.

只有進行基本的維護，我們的工作才能正常進行，如?。?/div>