When using concrete mixer, please pay attention to the pressure. If the pressure of the ladder type concrete mixer is too high, it is necessary to pay attention to this point. Stop using it. This can avoid some accidents and try to restore the pressure of concrete mixer to normal level. Here are some solutions for this problem.

混凝土攪拌機是這樣一種機器，其中帶有葉片的軸在圓筒中旋轉，或者可以混合和混合各種材料以形成混合物或合適的稠度?；旌蠙C類型很多，包括強制混合機，單軸混合機和兩軸混合機。

A concrete mixer is a machine in which a shaft with blades rotates in a cylinder, or various materials can be mixed and mixed to form a mixture or suitable consistency. There are many types of mixers, including forced mixers, single shaft mixers and two shaft mixers.

如果混凝土攪拌機在運行過程中承受過大的壓力，則過濾器很容易堵塞并且損壞了攪拌機。因此，在使用混凝土攪拌機時，請注意壓力范圍，以免由于攪拌機超壓而導致某些故障。

If the concrete mixer is under too much pressure during operation, the filter is easy to block and damage the mixer. Therefore, when using the concrete mixer, please pay attention to the pressure range, so as to avoid some faults caused by the overpressure of the mixer.

隨著混凝土攪拌機壓力的緩慢升高，過濾器通常會堵塞，應定期清潔。兩者都是氣缸問題，因為氣缸外部存在泄漏。水穩定的混合工位通常是由于活塞桿組件的疼痛，缺乏潤滑供應，密封件和密封件的磨損或損壞，氣缸中的雜質以及活塞桿上的劃痕引起的。

As the pressure of concrete mixer increases slowly, the filter will usually be blocked and should be cleaned regularly. Both are cylinder problems because of leakage from the outside of the cylinder. Water stable mixing stations are usually caused by pain in the piston rod assembly, lack of lubrication supply, wear or damage of seals and seals, impurities in the cylinder, and scratches on the piston rod.

我們需要及時調整活塞桿的中間位置，定期檢查油霧裝置的可靠性，并及時清洗。由于導電電磁閥的發展，該閥出現了故障，排氣模式被簡單地阻塞，形成了密封，并且有源閥卡在了電路故障中。使用調音臺時，我們可以使用整個工作站的封閉式設計。攪拌機的壓力是將間隔件和隔離室添加到混凝土攪拌機中。

We need to adjust the middle position of the piston rod in time, check the reliability of the oil mist device regularly, and clean it in time. Due to the development of conductive solenoid valve, the valve fails, the exhaust mode is simply blocked, forming a seal, and the active valve is stuck in the circuit fault. When using the mixer, we can use the closed design of the whole workstation. The pressure of the mixer is to add the spacer and isolation chamber to the concrete mixer.

另外，混凝土攪拌機的噪聲源主要是攪拌主體。對于機械設備，主要的噪音問題是機器本身的問題，從而提高了自身的生產水平和技術水平。研究了該位置的制造精度，并開發了一種可行且完善的加工方案，以大程度地減少設備組件之間的間隙，尤其是葉片和主攪拌機墊片之間的間距應盡可能小，以防止結石。。聲音變得清晰。

In addition, the main noise source of concrete mixer is mixing body. For machinery and equipment, the main noise problem is the problem of the machine itself, so as to improve its production level and technical level. The manufacturing accuracy of the position is studied, and a feasible and perfect processing scheme is developed to reduce the gap between the equipment components to a large extent, especially the gap between the blade and the main mixer gasket should be as small as possible to prevent stones.. The voice became clear.