The use of temperature of automatic concrete mixer is very critical, and its temperature is a key point that can not be ignored in the actual operation process of customers. It is expected that everyone will pay more attention to the temperature and condition of the mixer in the process of operation in case of common faults and bad things. I'll tell you how to adjust the temperature of the automatic concrete mixer.

攪拌機利用時要插上開關電源，將配有溶液的容器置放在加溫盤的中間，并把電機轉子放進容器的溶液中。

When using the mixer, plug in the switch power supply, place the container with solution in the middle of the heating plate, and put the motor rotor into the solution of the container.

打開開關電源，教唆燈亮了，然后順時針方向調節變速旋鈕，速率由慢快，調為所需速率，電機轉子轉動推動溶液開展拌和實際操作。需控溫加溫時，將溫度測量攝 像 頭插 進溶液中，非標準攪拌機并將電源插頭插 進攪拌機后排座上，調節溫度旋鈕所需溫度就可以。

Turn on the switch power supply, the abettor light is on, and then adjust the speed knob clockwise to adjust the speed from slow to fast to the required speed. The motor rotor turns to push the solution to carry out the actual mixing operation. To control the temperature, insert the temperature measurement camera into the solution, plug the power plug into the back seat of the non-standard mixer, and adjust the temperature knob to the required temperature.

若對溶液溫度精 密度要求恰當時，要用溫度計另外測量溶液溫度，再調節溫度旋鈕以做到要求溫度。若不需加溫，僅有把溫度調節旋鈕調室內溫度下列就可以。某些大伙兒按照上邊的方式來為自動混凝土攪拌機調節溫度就無須擔憂會展現難題了，之上是十分合理的方式詳細介紹，期待大伙兒很有可能按照流程開展

If the precision of solution temperature is required properly, a thermometer should be used to measure the solution temperature, and then the temperature knob should be adjusted to achieve the required temperature. If there is no need to heat up, just adjust the temperature adjustment knob below the indoor temperature. Some people adjust the temperature for the automatic concrete mixer according to the above way, so there is no need to worry about the problem. The above is a very reasonable way to introduce in detail, and we hope that everyone will probably carry out the work according to the process