The unique design of the concrete mixer can ensure that the original loading function is not affected during shovel transportation. The excavation part is folded as the counterweight, and the excavation loading part is used as the chassis support. The two parts do not affect each other and can also help each other. In the application project, the corresponding structural composition of the two busy excavators showing multi-function is more complex, so it is necessary to be more refined in management. It should be noted that machinery parking is a key link, and the key points of relevant management are as follows:

1、混凝土攪拌機應放在通風良好、干燥、清潔的場所，將機械的燃油控制桿置于怠速位置，各操縱桿置于空擋位置。

1. The concrete mixer shall be placed in a well ventilated, dry and clean place, the mechanical fuel control lever shall be placed in the idle position, and each control lever shall be placed in the neutral position.

2、準備長期停車時，應趁熱放凈機油、冷卻水及燃油。清洗油底殼及機油集濾器，并進行相應的技術保養。

2. When preparing for long-term shutdown, drain the engine oil, cooling water and fuel while it is hot. Clean the oil pan and oil strainer and carry out corresponding technical maintenance.

3、拆卸進、排氣管，自氣道向每個氣缸內加注脫水的干凈機油200g(即將機油加熱110-120度直到氣泡完全消失為止)，并轉動曲軸，使機油均勻附在氣門、氣缸套、活塞等零件表面;柴油機外表面應擦凈油污，水跡及灰塵，未涂漆零件應涂防銹油、(脫水機油加潤滑脂，溶化后混合均勻即成)，橡膠及塑料制品不應涂。

3. Remove the intake and exhaust pipes, fill 200g dehydrated clean engine oil into each cylinder from the air passage (i.e. heat the engine oil to 110-120 degrees until the bubbles disappear completely), and rotate the crankshaft to make the engine oil evenly attached to the surfaces of valves, cylinder liners, pistons and other parts; The external surface of the diesel engine shall be wiped clean of oil, water and dust. The unpainted parts shall be coated with antirust oil (dehydrated engine oil and grease shall be mixed evenly after melting), and the rubber and plastic products shall not be coated.

4、進、出水管口、進氣管口、排氣管口或消聲器口應用木塞堵住或用塑料布包好，防止雜物落入。

4. The inlet and outlet pipe orifices, inlet pipe orifices, exhaust pipe orifices or muffler orifices shall be blocked with wooden plugs or wrapped with plastic cloth to prevent sundries from falling into.

5、存放前，應視外表面防銹漆漆皮脫落面積的大小來確定是用補漆的辦法還是用整機重新噴漆的方法進行修補。

5. Before storage, it shall be determined whether to repair the rust proof paint on the outer surface by means of paint repair or repainting the whole machine according to the size of the peeling area of the rust proof paint on the outer surface.

以上內容由混凝土攪拌機整理發布的，希望可以幫助到您。更多精彩內容可以直接關注http://www.gdfcx.net

The above content is compiled and released by the concrete mixer. I hope it can help you. More exciting content can be directly concerned http://www.gdfcx.net