如果使用時間長，油封會磨損。方法：更換新油封即可。

If used for a long time, the oil seal will wear. Solution: replace the oil seal with a new one.

如果長期不換油，濾芯質量會變差，油會變得太臟，油封磨損會加快。方法：盡快更換液壓油和濾芯。

If the oil is not changed for a long time, the quality of the filter element will become poor, the oil will become too dirty, and the wear of the oil seal will accelerate. Solution: replace the hydraulic oil and filter element as soon as possible.

傳動軸失去平衡，劇烈振動，造成主軸擺動油封磨損。方法：及時修復和更換軸。

The transmission shaft is out of balance and vibrates violently, causing wear of the main shaft swing oil seal. Solution: repair and replace the shaft in time.

液壓油變質和乳化，降低潤滑性能并加速油封磨損。方法：盡快更換液壓油和濾芯。在嚴重的情況下，需要對系統進行清潔。

The deterioration and emulsification of hydraulic oil will reduce the lubricating performance and accelerate the wear of oil seal. Solution: replace the hydraulic oil and filter element as soon as possible. In severe cases, the system needs to be cleaned.

泵支架松動，開泵，泵固定螺栓松動，造成整個液壓泵振動，油封磨損。方法：經常檢查并排除全自動上料攪拌叉車出現故障的可能性，防止和避免出現故障。

The pump support is loose, the pump is started, and the pump fixing bolts are loose, causing vibration of the entire hydraulic pump and wear of the oil seal. Solution: regularly check and eliminate the possibility of failure of the full-automatic feeding and mixing forklift to prevent and avoid failure.

自動混凝土攪拌機系統回油不良，回油管路和散熱器堵塞，導致電機外殼壓力升高和油封泄漏。方法：堵塞物，穩定回油回路。

The oil return of the automatic concrete mixer system is poor, and the oil return pipeline and radiator are blocked, resulting in the pressure rise of the motor housing and oil seal leakage. Solution: remove the blockage and stabilize the oil return circuit.

如果散熱器不散熱，油溫會變得過高，粘度和潤滑性會降低，油封會過熱，油封無法工作。

If the radiator does not dissipate heat, the oil temperature will become too high, the viscosity and lubricity will be reduced, the oil seal will overheat and the oil seal will not work.

方法：散熱器上的障礙物并冷卻系統，以防止泵電機磨損。在嚴重的情況下，必須停止和停止發動機，并用水沖洗泵的電機和散熱器外殼進行冷卻。

Solution: remove the obstacles on the radiator and cool the system to prevent the pump motor from wearing. In severe cases, the engine must be stopped and stopped, and the pump motor and radiator housing must be flushed with water for cooling.

冬季運行時，由于預熱不足，油溫過低，油封、油封達不到理想的工作溫度。對策：啟動時停止油箱，怠速運轉10～20分鐘，待油溫恢復正常后更換油箱。

During winter operation, due to insufficient preheating and low oil temperature, the oil seal and oil seal can not reach the ideal working temperature. Countermeasures: stop the oil tank when starting, idle for 10 ~ 20 minutes, and replace the oil tank after the oil temperature returns to normal.

自動混凝土攪拌機液壓泵軸端油封易碎。嚴格遵守相關規定可以有效防止多次漏油。如果您遇到漏油，您需要冷靜下來并確定問題的具體原因。

The oil seal at the shaft end of the hydraulic pump of the automatic concrete mixer is fragile. Strict compliance with relevant regulations can effectively prevent multiple oil leaks. If you experience an oil leak, you need to calm down and determine the specific cause of the problem.

自動混凝土攪拌機“擋油”現象的內容便是這樣了，您可以關注我們網站www.gdfcx.net了解咨詢更多相關事項！

This is how to solve the problem of "oil retaining" of automatic concrete mixer. You can follow our website www.zkhntjbc Learn more about consulting!