混凝土攪拌機在進行運輸重載混凝土的時候要求安裝得當，才不會出現問題，而且之后要進行試運轉，那么你知道它是如何進行安裝以及后面的重載試運轉的嗎？下面小編為您分析分析。、
When transporting heavy-duty concrete, the concrete mixer is required to be installed properly so that there will be no problems, and then it will be tested. Do you know how it is installed and the subsequent heavy-duty test run? The following is a brief analysis for you
攪拌機的安裝注意事項如下：
The installation precautions of mixer are as follows:
1、傳動機構、工作裝置、離合器、制動器，均應緊固，靈活可靠，防護罩齊全。
1. The transmission mechanism, working device, clutch and brake shall be fastened, flexible and reliable, and the protective cover shall be complete.
2、應設防雨棚，機械周圍無泥水，干凈整潔，各種牌示齊全。
2. Rainproof sheds should be set up, and there should be no muddy water around the machinery, which should be clean and tidy, and all kinds of signs should be complete.
3、應安裝在牢固的臺座上，若長期使用，應埋設地腳螺栓，若短期使用，應在機下鋪設木枕并找平放穩。
3. It should be installed on a firm pedestal. If it is used for a long time, anchor bolts should be buried. If it is used for a short time, wooden pillows should be laid under the machine and leveled and placed stably.
4、鋼絲繩不得有銹蝕、斷絲、壓扁等報廢情況。
4. The steel wire rope shall be free of rust, broken wire, flattening and other scrapping conditions.
5、應安裝在平坦堅硬的地坪上，用木方或支撐架架牢，并保持水平，不準以輪胎代替支撐，使用時間較長的（一般超過3個月的）應將輪胎卸下妥善保管，輪軸端部應做好清潔和防銹工作。
5. It should be installed on a flat and hard floor, firmly supported by timbers or support frames, and kept horizontal. It is not allowed to replace the support with tires. The tires that have been used for a long time (generally more than 3 months) should be removed and kept properly. The ends of the axles should be cleaned and rustproof.
6、應設置“一機一閘一漏一箱”漏電保護器參數為30MA×0.1S，電機絕緣電阻值應大于0.5MΩ；保護零線不少于兩處，操作臺儀表、指示信號準確可靠。
6. The parameter of "one machine, one switch, one leakage and one box" leakage protector should be set as 30mA × 0.1s, the insulation resistance of the motor should be greater than 0.5m Ω; There are at least two protection zero lines, and the instruments and indicating signals on the console are accurate and reliable.
7、機體上保險掛鉤，料斗上吊耳應完好，當料斗升起時，應掛上保險鉤。
7. The safety hook on the machine body and the lifting lug on the hopper should be intact. When the hopper is raised, the safety hook should be hung.
攪拌機如何重載試運轉？
How to test run the mixer with heavy load?
1、按所需混凝土配比確定供水量，并調節時間繼電器到相應的給水時間。
1. Determine the water supply according to the required concrete proportion, and adjust the time relay to the corresponding water supply time.
2、啟動攪拌電動機運轉。
2. Start the mixing motor for operation.
3、關閉卸料門，在料斗內加入所需的混合料后，提升料斗，料斗應運行平穩并能自如停止在軌道的任意位置，若有打滑現象，應先將料斗放入坑底，然后調整制動電機上的大螺母。料斗提升正常，制動可靠后，向攪拌罐內投料，同時啟動水泵向攪拌罐內供水。
3. Close the discharge door, add the required mixture into the hopper, and then lift the hopper. The hopper should run smoothly and stop at any position of the track freely. If there is slip, put the hopper into the pit bottom first, and then adjust the big nut on the brake motor. After the hopper is lifted normally and the braking is reliable, feed into the mixing tank, and start the water pump to supply water to the mixing tank at the same time.
4、攪拌25-35秒后，啟動卸料門卸料。
4. After 25-35 seconds of mixing, start the unloading door to unload.
5、在上述各項試運轉過程中，如發現不正常情況，應立即停機檢查，排除故障，然后再次試驗，直到正常為止。
5. In the process of the above test run, if any abnormal condition is found, stop the machine immediately for inspection, eliminate the fault, and then test again until it is normal.
大家在駕駛
混凝土攪拌機的時候一定要注意上面的事項，否則就會使車輛的使用壽命縮短，還有就是在每天使用完了之后要對車輛及逆行清理，不讓混凝土粘結在上面。
When driving the concrete mixer, you must pay attention to the above matters, otherwise the service life of the vehicle will be shortened. In addition, after using it every day, you should clean the vehicle and retrograde to prevent the concrete from sticking to it.
The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.gdfcx.net And consult our staff, will serve you wholeheartedly.
全國服務熱線
點擊撥打服務熱線：400-879-1999
