1.自動上料一體攪拌車空壓機應水平安裝，固定并通風。
1. The air compressor of the automatic feeding integrated mixer truck shall be installed horizontally, fixed and ventilated.
2.強大的抗風雨能力，不暴露在陽光下。
2. Strong weather resistance, not exposed to the sun.
3.調整氣動自動開關的上限和下限。如果壓力太低，氣缸會減速，如果壓力太高，氣動系統的氣密性會降低。
3. Adjust the upper and lower limits of the pneumatic automatic switch. If the pressure is too low, the cylinder will slow down. If the pressure is too high, the air tightness of the pneumatic system will be reduced.

4.使用自動上料一體攪拌車檢查油位，并確保油位在量油尺的頂線和底線之間。當油位接近下限時，添加新油。
4. Use the automatic feeding integrated mixer to check the oil level and ensure that the oil level is between the top line and the bottom line of the dipstick. When the oil level approaches the lower limit, add new oil.
5.確保皮帶正確張緊。用手指推動皮帶，使其松開約10毫米。更換傳送帶時，必須更換整個組以保持共同的張力。
5. Ensure that the belt is tensioned correctly. Push the belt with your fingers to loosen it by about 10mm. When replacing the conveyor belt, the entire group must be replaced to maintain a common tension.
6.由于氣體系統中充滿油，因此需要足夠量的油才能正常運行。只有這樣，才能同時使用獨立式混合器的功率來延長氣體系統的使用壽命。
6. Since the gas system is full of oil, sufficient oil is required for normal operation. Only in this way can the power of the independent mixer be used at the same time to prolong the service life of the gas system.