混凝土攪拌機在安裝時候有油污不用慌，掌握技巧很關鍵，下面小編就來給您講講相關的技巧方法。

When the concrete mixer is installed with oil stains, don't panic. It's very important to master the skills. The following editor will tell you about the relevant skills and methods.

攪拌機的液壓泵吸油口應安裝粗濾器，吸油口應與油箱底部有一定距離； 攪拌機出油口應安裝高壓精濾器，過濾效果應滿足系統工作要求，防止污染。 物料堵塞引起的液壓系統故障； 過濾網應安裝在攪拌機的液壓油箱隔板上，以去除回油過濾器未過濾的雜質。

The oil suction port of the hydraulic pump of the mixer should be installed with a coarse filter, and the oil suction port should be a certain distance from the bottom of the oil tank; High pressure fine filter shall be installed at the oil outlet of the mixer, and the filtering effect shall meet the working requirements of the system to prevent pollution. Hydraulic system failure caused by material blockage; The filter screen shall be installed on the diaphragm of the hydraulic oil tank of the mixer to remove the unfiltered impurities of the oil return filter.

攪拌機的液壓缸上應安裝金屬保護圈，防止污物帶入缸內，防止泥水和光輻射侵蝕液壓缸造成泄漏； 液壓元件安裝前應檢查、清洗內鐵。 灰塵和雜質； 定期檢查液壓油，一旦油液變質、起泡、沉淀、油水分離等，應立即清洗系統并換油。

Metal protective rings should be installed on the hydraulic cylinder of the mixer to prevent dirt from entering the cylinder and prevent leakage caused by muddy water and light radiation erosion of the hydraulic cylinder; Check and clean the inner iron before installing the hydraulic components. Dust and impurities; Check the hydraulic oil regularly. Once the oil deteriorates, bubbles, precipitates, oil-water separation, etc., clean the system and change the oil immediately.

新油加入攪拌機油箱前，應先靜置過濾后再加入。 必要時可設置中間油箱，用于新油的沉淀和過濾。避免“高-檔低速”駕駛，這使得油料不完全燃燒，從而積累在油管內形成油泥。

Before the new oil is added into the oil tank of the mixer, it should be filtered before adding. If necessary, an intermediate oil tank can be set for sedimentation and filtration of new oil. Avoid "high gear low speed" driving, which makes the oil incomplete combustion, thus accumulating in the oil pipe to form sludge.

不要長時間的怠速運轉和低速行駛，這樣是 容易使得油料不完全燃燒，積累形成碳層。使用純凈度和品質達標的油料，油料的純度高，是的油料能夠快速充分的燃燒，這樣就會減少油泥的生成量。因此，使用匹配的攪拌機油料顯得十分有必要了。

Don't idle for a long time and drive at low speed, which is easy to cause incomplete combustion of oil and accumulation of carbon layer. Use the oil with purity and quality up to standard. The purity of the oil is high. Yes, the oil can burn quickly and fully, which will reduce the amount of sludge. Therefore, it is necessary to use matching mixer oil.

此外及時更換失效油封。混凝土攪拌機上很多動置部位會因安裝不妥，軸頸與油封刃口不同心，偏擺而甩油。有些油封使用過久會因橡膠老化而失去彈性。發現滲漏應及時更新。另外，油底殼放油螺塞若未擰緊或回松脫落，容易造成機油流失，繼而發生“燒瓦抱軸”的機損事故。

In addition, replace the failed oil seal in time. Many moving parts on the concrete mixer will shed oil due to improper installation, misalignment between the journal and the oil seal blade, and deflection. Some oil seals will lose elasticity due to rubber aging after being used for too long. If leakage is found, it should be updated in time. In addition, if the oil drain plug of the oil pan is not tightened or loosened, it is easy to cause oil loss, and then the machine damage accident of "Bush burning and shaft holding" occurs.

攪拌機安裝時出現油污別擔心有預防技巧的問題就講解到這里了，如果您對此有不同的想法可以關注網站http://www.gdfcx.net分享出來。

Don't worry about oil stains when installing the mixer. That's all for the prevention skills. If you have different ideas about this, you can follow the website http://www.gdfcx.net Share it.