1、 Precautions during loading and unloading

1.自上料攪拌輸送一體機應在準備車輛之前定期檢查車輛狀況，以確保車輛狀況良好。檢查車輛狀況，檢查混合罐中的混合物是否充足以及是否已稀釋。確保每輛車都配備了足夠的混合氣。

1. Before preparing the vehicle, the self feeding mixing and conveying integrated machine shall regularly check the vehicle condition to ensure that the vehicle is in good condition. Check the condition of the vehicle and check whether the mixture in the mixing tank is sufficient and diluted. Make sure each vehicle is equipped with enough mixture.

2.在自上料攪拌輸送一體機等待裝載之前，應將油箱倒置直油箱中的水完全排空，然后倒入混合地板中以使油箱向前移動。速度可以適當提高。警報器關閉后，警鐘將響起并遠離。料口。料口。汽車開在水槽附近。當駕駛員下車時，油箱速度可能會減慢。根據天氣情況調整水箱的轉速。天氣寒冷時，速度可能更快，天氣炎熱時，速度可能會變慢。

2. Before waiting for loading from the feeding, mixing and conveying all-in-one machine, turn the oil tank upside down until the water in the oil tank is completely drained, and then pour it into the mixing floor to move the oil tank forward. The speed can be appropriately increased. When the alarm is off, the alarm will sound and stay away. Material mouth. Material mouth. The car drove near the sink. The fuel tank speed may slow down when the driver gets off the vehicle. Adjust the speed of the water tank according to the weather conditions. The speed may be faster in cold weather and slower in hot weather.

3.自上料攪拌輸送一體機在運輸過程中應保持穩定。在上坡和拐角處，它應該穩定且緩慢。駕駛時，請始終觀察后視鏡，看是否有混凝土灑落。如果發現混凝土裝料過多或車輛的速度不穩定，則需要及時調整車輛的速度。發現過多的填充物。根據當時的實際情況處理此現象，駕駛員應注意這一點。下次裝載汽車時，您必須減少重量。

3. The self feeding mixing and conveying integrated machine shall be stable during transportation. It should be stable and slow on uphills and corners. When driving, please always observe the rearview mirror to see if there is concrete spilled. If excessive concrete loading or unstable vehicle speed is found, the vehicle speed needs to be adjusted in time. Too much filler was found. Deal with this phenomenon according to the actual situation at that time, and the driver should pay attention to this point. You must reduce the weight the next time you load the car.

二，自動給料攪拌機的駕駛員應注意：駕駛員應遵守職業道德，施工人員在場時不得談論本公司的內部事務，特別是混凝土原料，混凝土攪拌技術攪拌機的駕駛員應遵循現場調度和質量檢查的安排。在現場調度和質量檢查的情況下，現場調度員和質量檢查員與施工人員進行溝通。

2、 The driver of automatic feeding mixer should pay attention to: the driver should abide by professional ethics. The construction personnel should not talk about the internal affairs of the company, especially the concrete raw materials. The driver of concrete mixing technology mixer should follow the arrangement of on-site dispatching and quality inspection. In the case of on-site dispatching and quality inspection, the on-site dispatcher and quality inspector shall communicate with the construction personnel.

三，具體相關知識

3、 Specific relevant knowledge

1.混凝土和可加工性：它反映了混凝土的質量?；炷帘环Q為良好的可加工性。否則，據說可加工性不好?？杉庸ば园ɑ炷亮鲃有?，保水性和粘結性的三個指標。

1. Concrete and workability: it reflects the quality of concrete. Concrete is known as good workability. Otherwise, it is said that the machinability is not good. Workability includes three indexes of concrete fluidity, water retention and cohesiveness.

2.混凝土強度等級：俗稱混凝土標簽，它反映了混凝土的28d強度指標。根據現場要求，一般有C10，C15，C20，C25，C30，C35，C40。

2. Concrete strength grade: commonly known as concrete label, it reflects the 28d strength index of concrete. According to the site requirements, there are C10, C15, C20, C25, C30, C35 and C40 in general.