混凝土攪拌機等工程機械對設備的操作有著各種各樣的要求，確保設備長期穩定的工作狀態。新手操作需要明確幾點要求：

Construction machinery such as concrete mixers have various requirements for equipment operation to ensure long-term stable working conditions of equipment. The novice operator needs to specify several requirements:

1、操作人員在進行駕駛與作業之前，應熟知混凝土攪拌機的各種性能、結構、技術保養、操作方法、并按規定進行操作。

1. Before driving and operating, the operator shall be familiar with the performance, structure, technical maintenance and operation methods of the concrete mixer, and operate as required.

2、除駕駛室外，機上其他地方嚴禁乘人。

2. It is strictly forbidden to ride in other places except the cab.

3、向車內卸料時須將鏟斗提升到不會觸及車箱檔板的高度，嚴防鏟斗碰車箱，嚴禁將鏟斗從攪拌機駕駛室頂上越過。

3. When unloading materials into the vehicle, the bucket must be lifted to a height that will not touch the truck baffle. It is strictly prohibited to touch the truck with the bucket. It is strictly prohibited to cross the bucket from the top of the mixer cab.

4、下坡時采用自動減速，不可踩離合器踏板，以防切斷動力發生溜車事故。

4. Automatic deceleration shall be adopted when going downhill, and the clutch pedal shall not be stepped on to prevent sliding accident due to cutting off the power.

5、混凝土攪拌機涉水后應立即停機檢查，如發現因浸水造成制動失靈，則應進行連續制動，利用發熱排除制動片內的水分，以盡快使制動器恢復正常。

5. After wading, the concrete mixer shall be stopped immediately for inspection. If it is found that the brake fails due to water immersion, it shall be continuously braked to remove the moisture in the brake pad by heating, so as to restore the brake to normal as soon as possible.

6、帶負荷停機或作業后立即停機。

6. Shutdown with load or immediately after operation.

混凝土攪拌機帶負荷停機或作業后立即停機，冷卻系統隨即停止工作，散熱能力急劇下降。工作產生的大量熱量積聚在熱源附近不能及時散發，使氣缸蓋、缸套、缸體等受熱部件的冷卻水沸騰，機件過熱，高溫燒蝕。

When the concrete mixer is shut down with load or immediately after operation, the cooling system immediately stops working, and the heat dissipation capacity drops sharply. A large amount of heat generated by the work can not be timely distributed near the heat source, which makes the cooling water of the cylinder head, cylinder liner, cylinder block and other heated parts boil, and the parts overheat and ablate at high temperature.

同時還會使附著其表面的機油變質，造成下次啟動困難。此外，帶渦輪增壓器的柴油機，若突然停機，會使增壓器升溫600℃左右，易造成密封環損壞。

At the same time, the oil attached to the surface will deteriorate, causing difficulties in the next start. In addition, if the diesel engine with turbocharger is shut down suddenly, the turbocharger will rise to about 600 ℃, which is easy to damage the sealing ring.

因此，混凝土攪拌機在熄火前應卸除負荷，并空載運轉3～5min，使機溫降40℃以下，水溫降50℃以下時，方可停機。

Therefore, before flameout, the concrete mixer shall be unloaded and operated with no load for 3~5min to reduce the temperature of the mixer to below 40 ℃. The mixer can only be stopped when the water temperature drops below 50 ℃.

關于新手操作攪拌機需要明確幾點要求問題的相關解答就是這樣了，您對此有什么想問的可以隨時來聯系我們http://www.gdfcx.net！

This is the answer to the questions that novices need to clarify when operating the mixer. Please feel free to contact us if you have any questions http://www.gdfcx.net ！