自動混凝土攪拌機在使用過程中難免會有一些問題出現，比如他的零部件--輪胎，這在工程中可是起到大作用的東西，下面小編就來講講攪拌機零部件的使用常識。

It is inevitable that some problems will occur during the use of the automatic concrete mixer. For example, its parts -- tires, which play an important role in the project, will be introduced in the following sections.

輪胎負荷

Tyre load

車輛的負荷越大，則輪胎的壽命越短，這點是毋庸置疑的。尤其是在超載的情況下，更加突顯。正規輪胎廠家生產的輪胎都標又載重指數。輪胎應在指定的載重指數所對應的大載重量內使用。

There is no doubt that the greater the load of the vehicle, the shorter the life of the tire. Especially in the case of overload, it is more prominent. The tires produced by regular tire manufacturers are standard load index. Tires shall be used within the heavy load corresponding to the specified load index.

行駛速度

Travel speed

正規輪胎廠家生產的輪胎都標又素服級別指數。輪胎應在指定的速度計別指數所對應的高行駛速度內使用。

The tires produced by regular tire manufacturers are all standard and simple service grade indexes. Tires shall be used at the high driving speed corresponding to the designated speed indicator.

輪胎溫度

Tyre temperature

車輛在行駛過程中，輪胎由于受到伸張、壓縮和摩擦，引起胎溫升高。過高的溫度容易加劇輪胎磨損甚發生爆胎。

When the vehicle is running, the tire temperature rises due to stretching, compression and friction. Excessive temperature is easy to aggravate tire wear and even tire blowout.

底盤狀況

Chassis condition

前、后車軸的平行度、四輪定位、制動裝置工作狀況以及底盤其他機件技術、狀況都會不同程度地影響到車輛輪胎的壽命。一旦出現嚴重的交通碰撞事故，車主一定要將車輛開到維修站進行底盤狀況檢查及調整。

The parallelism of the front and rear axles, four-wheel alignment, working conditions of the braking device, and the technology and conditions of other chassis parts will affect the service life of the vehicle tires to varying degrees. In case of a serious traffic collision, the owner must drive the vehicle to a professional maintenance station for chassis condition inspection and adjustment.

胎面無裂紋

No cracks on the tread

定時檢查商品攪拌機輪胎表面有無裂紋、變形等缺陷。商品攪拌機輪胎的花紋溝由于行駛磨損而逐漸變淺，如果磨平就會失去排水防滑等作用，商品攪拌機各項性能將大大降低，而看似細小的裂紋更是高速行駛時爆胎的隱患。此外還要注意及時凹槽中的小石子。

Regularly check the surface of the commercial mixer tire for cracks, deformation and other defects. The tread groove of the commercial mixer tire gradually becomes shallow due to driving wear. If it is smoothed, it will lose the function of drainage and anti-skid, and the performance of the commercial mixer will be greatly reduced. The seemingly small cracks are the hidden danger of tire burst when driving at high speed. In addition, pay attention to the timely removal of small stones in the groove.

避免急剎車

Avoid sudden braking

起步不可過猛，要避免頻繁使用剎車和緊急剎車，以免因商品攪拌機輪胎與地面拖曳而加速胎面磨損；在拐彎會車、超車、通過交叉路口、狹窄路面、鐵路道口等地段時，應掌握適當的車速且要注意路面、行人、車輛動態，做好制動準備，減少頻繁制動，避免緊急制動，從而降低商品攪拌機輪胎磨損；面臨無法避開的碎玻璃或其他異物時，要減速通過，千萬不要急剎車，因為急剎車造成壓強增大，玻璃碎片和異物更容易扎入商品攪拌機輪胎。

Do not start too hard, and avoid frequent use of the brake and emergency brake to avoid accelerated tread wear due to the drag of the commodity mixer tire and the ground; When meeting, overtaking, crossing intersections, narrow roads, railway crossings and other sections, you should master the appropriate speed, pay attention to the dynamics of the road, pedestrians and vehicles, make braking preparations, reduce frequent braking, avoid emergency braking, so as to reduce the wear of the tires of the commodity mixer; When you are faced with broken glass or other foreign matters that cannot be avoided, you should slow down and do not brake suddenly. Because the pressure increases due to sudden braking, glass fragments and foreign matters are more likely to get into the tires of the commodity mixer.

此外攪拌機輪胎在夏季長時間行駛或高速行駛時容易過熱，同時氣壓增高。此時應停車散熱，嚴禁放氣降壓或潑水降溫，以防胎面橡膠的非正常老化。關注我們http://www.gdfcx.net，了解更多內容！

In addition, the mixer tires are easy to overheat when driving for a long time or at high speed in summer, and the air pressure increases. At this time, the vehicle shall be stopped to dissipate heat. It is strictly forbidden to deflate and depressurize or splash water to cool down, so as to prevent abnormal aging of tire tread rubber. Follow us http://www.gdfcx.net , learn more!